The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> Stripline to Microstrip transition using Multilayer Boards https://designers-guide.org/forum/YaBB.pl?num=1265698271 Message started by avins on Feb 8th, 2010, 10:51pm |
Title: Stripline to Microstrip transition using Multilayer Boards Post by avins on Feb 8th, 2010, 10:51pm Hello, My project is Strip line to Micro strip transition using multilayer circuit boards. The paper from which I have got the project is attached. This project is to be simulated using Ansoft HFSS v11. I have visualized the project as show in on Pg.9 in the document. Both the documents - my project word document and HFSS file is attached. Regards, Avinash |
Title: Re: Stripline to Microstrip transition using Multilayer Boards Post by pancho_hideboo on Feb 9th, 2010, 5:47am The following your post is completely same as this post. http://www.designers-guide.org/Forum/YaBB.pl?num=1265698420 Don't do multiple post of same contents. |
Title: Re: Stripline to Microstrip transition using Multilayer Boards Post by loose-electron on Feb 9th, 2010, 5:34pm and your question is? |
Title: Re: Stripline to Microstrip transition using Multilayer Boards Post by avins on Feb 9th, 2010, 10:04pm Hello, The thing is can anyobe chek whether what I have visualised(design), Is it correct.I have attached the HFSS design.Actually, in the paper, it is given that ground plane has thickness of 17.5 micro metre. I make a sheet cutout using polyline. I need to subtractground plane and polyline sheet, Here it gives an error, only If i make thickness of ground plane as 0mm, I am able to subtract properly. Regards, Avin |
Title: Re: Stripline to Microstrip transition using Multilayer Boards Post by avins on Feb 9th, 2010, 10:06pm Hello, The nasa technical paper is attached. Regards, Avin |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |