The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> input referred noise calculated by ADE https://designers-guide.org/forum/YaBB.pl?num=1271386358 Message started by Dipankar on Apr 15th, 2010, 7:52pm |
Title: input referred noise calculated by ADE Post by Dipankar on Apr 15th, 2010, 7:52pm Dear All, The unit of input referred noise as reported by ADE is V/sqrt(Hz). Can someone tell whether this V is Vrms or only V ? The noise spec set by system designer is in vrms/sqrt(Hz). |
Title: Re: input referred noise calculated by ADE Post by ywguo on Apr 16th, 2010, 5:43am Hi Dipanker, I don't understand why the noise spec is in vrms/sqrt(Hz). Bear in mind this is power spectral density of noise, not integrated power or rms value. The unit is usually V/sqrt(Hz) or V^2/Hz in engineering. Yawei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |