The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> Save and plot node voltage in post-layout simulation https://designers-guide.org/forum/YaBB.pl?num=1275882813 Message started by ywguo on Jun 6th, 2010, 8:53pm |
Title: Save and plot node voltage in post-layout simulation Post by ywguo on Jun 6th, 2010, 8:53pm Hi Guys, I failed to save and plot node voltage in a post-layout simulation. Last week I ran a post-layout simulation with RC extracted view. That was extracted using Assura. I tried to save and plot a few nodes inside the RC extracted view. I set up the config view, chose the schematic view first. Then select a few nodes in the schematic. Then I switched to RC extracted view in Hierarchy editor and Run simulation. But two nodes in all my selections are not saved. The following is detailed information in ncsim.log. Quote:
Any comments are appreciated. Yawei |
Title: Re: Save and plot node voltage in post-layout simulation Post by boe on Jun 25th, 2010, 7:47am ywguo, The message suggests that the name does not exist. A few ideas: Did you check your extracted view/netlist that it contains the name? Is the hierarchy the same, did any flattening occur? BOE |
Title: Re: Save and plot node voltage in post-layout simulation Post by thechopper on Jul 15th, 2010, 7:06pm I faced similar issues like the ones Yawei had. However I was able to plot any node simulated from the extracted view by selecting the corresponding net from the schematic view. That worked for me so far. Best Tosei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |