The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Offset measurement of latch in comparators https://designers-guide.org/forum/YaBB.pl?num=1276765434 Message started by Parveen on Jun 17th, 2010, 2:03am |
Title: Offset measurement of latch in comparators Post by Parveen on Jun 17th, 2010, 2:03am How can we measure the offset of a latch? |
Title: Re: Offset measurement of latch in comparators Post by raja.cedt on Jun 17th, 2010, 4:06am hi, ideally speaking you have to specify offset at a given common mode, but simple way of doing is sweep input voltage and see where it is tripping (provided you don't have any hysteresis in the comparator). Very accurate method is http://www.designers-guide.org/Analysis/comparator.pdf Thanks, Rajasekhar. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |