The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Other CAD Tools >> Physical Verification, Extraction and Analysis >> please help me about calibreview https://designers-guide.org/forum/YaBB.pl?num=1279076145 Message started by Read_wdx on Jul 13th, 2010, 7:55pm |
Title: please help me about calibreview Post by Read_wdx on Jul 13th, 2010, 7:55pm Hi,every one when I use calibre 2008 pex to extract parasitical R and C of my circuit, I can not get correct calibreview file, this calibreview file does not contain any parasitic component( R and C),and it does not include pins.I try many setups for cailbre,but not work,I need help. I am new man about calibre,but now I must use it to verify my RF IC circuit.I use TSMC 13rf technogy process,and I use calibre 2008 to verify my circuit. Tanks all |
Title: Re: please help me about calibreview Post by ywguo on Jul 14th, 2010, 7:27pm Hi wdx, TSMC provides a file named calview.cellmap that maps all extracted devices to the corresponding cells in tsmc PDK. Usually the mapping of parasitic res and cap are not in that file. But it's not a problem.
Good luck Yawei |
Title: Re: please help me about calibreview Post by Jacki on May 15th, 2013, 6:03am Hi, I use the same to map the device, but why only "r" and "c" shows the pop-up window, not other devices from the design kits. So it means in the calview.calibremap file, I only have "r" and "c". Any one knows how to map the devices from the design kits? Jacki |
Title: Re: please help me about calibreview Post by Jacki on May 15th, 2013, 6:36am I find the file. Thank you. Jacki. |
Title: Re: please help me about calibreview Post by ywguo on Nov 13th, 2013, 12:25am Hi Jacki, All other cells except 'r' and 'c' for parasitics are defined in calview.cellmap. --Yawei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |