The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> make the default save option from "allpub" to "selected" https://designers-guide.org/forum/YaBB.pl?num=1281162613 Message started by newic on Aug 6th, 2010, 11:30pm |
Title: make the default save option from "allpub" to "selected" Post by newic on Aug 6th, 2010, 11:30pm how do I make the default save option from "allpub" to "selected" in the Cadence cdsinit file?? |
Title: Re: make the default save option from "allpub" to "selected" Post by pancho_hideboo on Aug 7th, 2010, 12:44am newic wrote on Aug 6th, 2010, 11:30pm:
I assume you use Cadence Spectre. Add following in ".cdsinit". Code:
The followings are general notes for you. - Always describe correct tool's name and vendor's name which you use as tool or simulator. - Don't do multiple posts which are same content. - Don't request source code or behavioral model without any efforts. - There are many simulators which have analyses called as PSS, PAC and Pnoise. - Describe in detail with using correct terminologies. - Warnigns are different from Errors. - ADS is not name of simulator. - There is no tool which name is Cadence. - Don't use Direct Plot of Cadence ADE blindly without knowing definition. - All gains in Direct Plot of Cadence ADE are "right", "true" and "practical" voltage gain. - Don't mix up Simulation with Post Processing. They are completely different phase. - MATLAB are different from Simulink. - Learn measurements using actual instruments. Not "EDA Tool Play |
Title: Re: make the default save option from "allpub" to "selected" Post by newic on Aug 7th, 2010, 7:05pm thank you ;) |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |