The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Monte Carlo/TSMC https://designers-guide.org/forum/YaBB.pl?num=1282124333 Message started by memomemomemo on Aug 18th, 2010, 2:38am |
Title: Monte Carlo/TSMC Post by memomemomemo on Aug 18th, 2010, 2:38am Hi! I am doing Monte Carlo simulation ( 90nm TSMC Process) with cadence5. I can see the process variation for mos transistors however not the mismatch. How can I find out what is wrong? Should I enable or add a model library? Thanks! Mehmet |
Title: Re: Monte Carlo/TSMC Post by mydreamhouse on Aug 22nd, 2010, 5:13am before run monte carlo simulation, you should do: (1)use mismatch symbol in PDK (2)use mc_ section in library |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |