The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> 50 ohm buffer design
https://designers-guide.org/forum/YaBB.pl?num=1286517746

Message started by newic on Oct 7^th, 2010, 11:02pm

Title: 50 ohm buffer design
Post by newic on Oct 7^th, 2010, 11:02pm

I am looking for 50 ohm buffer designs. Is there any good document about it?

1. When I simulate the 50ohm buffer, what is the load? Currently i use a ac capacitor and followed by a 50ohm resistor.

2. How to model from 50ohm buffer output to pico-probe?

3. What is the capacitive load seen from the buffer output?