The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> hspice in ADE https://designers-guide.org/forum/YaBB.pl?num=1286791589 Message started by sivacha on Oct 11th, 2010, 3:06am |
Title: hspice in ADE Post by sivacha on Oct 11th, 2010, 3:06am Hi When i tried to run hspice on any schematic through ADE, i am getting some error like " Enter the name of the output file: (input.lis) " in the log window. But i can not edit log file. Where can I enter the output file name? Can any body suggest a solution??? Thanks. |
Title: Re: hspice in ADE Post by Geoffrey_Coram on Oct 11th, 2010, 10:22am Probably your ADE isn't configured properly. I think there's a command-line argument that tells HSpice to use input.lis without prompting (assuming the netlist was input.sp). |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |