The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> How to do post-layout simulation with Calibre netlist in ADE? https://designers-guide.org/forum/YaBB.pl?num=1289139340 Message started by Yutao Liu on Nov 7th, 2010, 6:15am |
Title: How to do post-layout simulation with Calibre netlist in ADE? Post by Yutao Liu on Nov 7th, 2010, 6:15am Dear all, I am using Cadence 6.1. And I want to know how to do post-layout simulation in ADE while the netlist is generated by Calibre? Thanks in advance. Yutao |
Title: Re: How to do post-layout simulation with Calibre netlist in ADE? Post by Paul H on Nov 25th, 2010, 1:51am The simplest method of doing this is to extract your layout to a Calibreview instead of a netlist and then change your switch view list to include this view when netlisting from your test bench top level. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |