The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to plot part of the waveform in cadence ADE https://designers-guide.org/forum/YaBB.pl?num=1289248689 Message started by xuedashun on Nov 8th, 2010, 12:38pm |
Title: how to plot part of the waveform in cadence ADE Post by xuedashun on Nov 8th, 2010, 12:38pm I have 100us simulation result. If the startup part (say 0-5us) is not good and I don't want to plot it at all. I want to plot is from 5us-100us. Is there any way to set the 5us-100us as a default option so that it can be plotted automatically each time after the simulation is done? Thank you! |
Title: Re: how to plot part of the waveform in cadence ADE Post by aamar on Nov 8th, 2010, 11:34pm In the chossing analysis window, where do you setup the transient analysis parameters, there is an option button. Choose it and set the outputstart in it to the 5u. Best regards, aamar |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |