The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Envelope sim time limits? https://designers-guide.org/forum/YaBB.pl?num=1291769423 Message started by wave on Dec 7th, 2010, 4:50pm |
Title: Envelope sim time limits? Post by wave on Dec 7th, 2010, 4:50pm Hi all - I'm running Envelope Analysis, looking at Voltage vs Time. ADE 5.10.41.500.6.134 When I run a relatively short Stop Time of 1mS, things work OK. Waveforms plot OK; perhaps 7 baseband cycles. When I run longer sims (10-20mS), there is NO output. ADE, Direct Plot Form, acts as if the data wasn't saved; yet there are huge output files: envlp.fd/dt.envlp Since I'd like to sim slowly incrementing dynamic waveforms, this is a limitation. Any thoughts? thanks, Wave 8-) |
Title: Re: Envelope sim time limits? Post by Geoffrey_Coram on Dec 14th, 2010, 6:26am Can you start wavescan stand-alone and browse to those output files? This might tell you whether the problem is ADE or the files. |
Title: Re: Envelope sim time limits? Post by Andrew Beckett on Jan 2nd, 2011, 2:22am Which version of the simulator is being used? Are you using harmonic balance or shooting? How big are the files (do an ls -l on the directory and post the results). Not sure I can immediately think of a good reason for a problem, but the above might provide enough pointers to pinpoint the problem. Best Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |