The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Transient Simulation under Spectre https://designers-guide.org/forum/YaBB.pl?num=1292600227 Message started by pcardoso73 on Dec 17th, 2010, 7:37am |
Title: Transient Simulation under Spectre Post by pcardoso73 on Dec 17th, 2010, 7:37am Hi, I would like to do a transient simulation, but save only transient points after a certain time. For eg. my simulation runs from 0 until 500us, and I would like to save only from 400u to 500u. How can I do this ? Best regards, Pedro Cardoso |
Title: Re: Transient Simulation under Spectre Post by Ken Kundert on Dec 17th, 2010, 10:13pm use the outputstart transient analysis parameter. -Ken |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |