The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Error using NPORT
https://designers-guide.org/forum/YaBB.pl?num=1296439674

Message started by melbadry on Jan 30^th, 2011, 6:07pm

Title: Error using NPORT
Post by melbadry on Jan 30^th, 2011, 6:07pm

Hi all,

I am trying to use nport to use for tabulated s-parameters with 8 ports. The file is in touchstone format. When I try to simulate I get the following error:

Error found by spectre during circuit read-in.
ERROR (SFE-874): "input.scs" 23: Unexpected keyword "options". Expected equals.

Is there a work-around for this problem?

I am using cadence 6.1.3 with mmsim version 6.2

Title: Re: Error using NPORT
Post by sheldon on Jan 31^st, 2011, 5:21am

Melbadry,

It is not clear what the issue is from the post. If you check the
nport help, options is not mentioned. The message does not appear
to be related to the nport.

spectre -h nport | grep options

Could you post line #23 from your netlist?

Best Regards,

Sheldon