The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> chopper stabilization with Pnoise & PSS simulation https://designers-guide.org/forum/YaBB.pl?num=1297858466 Message started by webbubm on Feb 16th, 2011, 4:14am |
Title: chopper stabilization with Pnoise & PSS simulation Post by webbubm on Feb 16th, 2011, 4:14am hi all~ Now I use Pnoise & PSS to simulate chopper noise analysis. And I use one stage fully-difficential OP and four switches to modulate noise at output of OP without C-load at switches outputs. but with PNOISE analysis I can not see the flicker noise at chopper frequency, the flicker noise is also there just lower than before choppered. could anyone help me how to use it? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |