The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> ELDO SST Simulations - chopper amplifiers https://designers-guide.org/forum/YaBB.pl?num=1298458890 Message started by Braski on Feb 23rd, 2011, 3:01am |
Title: ELDO SST Simulations - chopper amplifiers Post by Braski on Feb 23rd, 2011, 3:01am Does anyone know something about SST simulations with ELDO? I read the manual of ELDO-RF, but i can't figure out to apply the examples and features of this kind of analysis to my case of chopper amplifiers. If u know the basis of these kind of analysis, you may explain something. I also read the paper on simulation of SC with cadence PSS, but it's not my software so it's hard to use it with ELDO. However, if u can give me some ideas on how to simulate a chopper amplifier even in cadence PSS, maybe i'll be able to transfer these infos on ELDO SST with a bit of work. |
Title: Re: ELDO SST Simulations - chopper amplifiers Post by philcorb on Feb 28th, 2011, 8:08am Hi, Set the sst frequency to the clock frequency (say 1MHz) and add a reasonable number of harmonics, something like .sst fund1=1Meg nharm=30 setup a transfer function analysis .sstxf V(Vout) lin 30 1K 100K get outputs to the .wdb file .probe fsst V .probe tsst V .probe sstxf V Hope that helps, or at least gets you going. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |