The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> How to figure out cutoff frequency using scope for LC filter post SMPS https://designers-guide.org/forum/YaBB.pl?num=1300602736 Message started by witssq on Mar 19th, 2011, 11:30pm |
Title: How to figure out cutoff frequency using scope for LC filter post SMPS Post by witssq on Mar 19th, 2011, 11:30pm I am using commercial SMPS +5, +/-15V output. Against SMPS output, I applied LC filter, and achieved 45mV noise down to 20mV noise, but I need about 5mV or below. Please anyone help me about how to find cutoff frequency not easy to figure out The microscopic view is after currently filtered. Best regards, |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |