The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> bsource - convert to ADS https://designers-guide.org/forum/YaBB.pl?num=1301961984 Message started by apprentice on Apr 4th, 2011, 5:06pm |
Title: bsource - convert to ADS Post by apprentice on Apr 4th, 2011, 5:06pm vb ( 3 2 ) bsource v = i(va)*5 + 1 va ( 2 1 ) vsource dc = 0 ---------------------------- To convert the above netlist to a schematic in Agilent ADS, what's the right way? (Eqn based-nolinear component? Nonlinear CCVS?) thanks |
Title: Re: bsource - convert to ADS Post by apprentice on Apr 4th, 2011, 7:33pm thanks for hint. not sure if SDD1P or SDD2P should be used. tried SDD2P. could you comment the attached screen capture? |
Title: Re: bsource - convert to ADS Post by Geoffrey_Coram on Apr 6th, 2011, 9:31am If I were doing it, I'd use a simple CCVS with a gain of 5 in series with a 1-V dc voltage source. (I don't know what SDD1P is.) |
Title: Re: bsource - convert to ADS Post by Ken Kundert on Apr 6th, 2011, 4:45pm SDD1P = symbolically defined device - one port (I believe) This seems all very complicated if all you want is a 5 Ohm resistor in series with a 1V voltage source. -Ken |
Title: Re: bsource - convert to ADS Post by apprentice on Apr 6th, 2011, 6:10pm thanks Geoffrey and Ken. I'll think more about the model and try the schematics as you suggested. |
Title: Re: bsource - convert to ADS Post by Geoffrey_Coram on Apr 7th, 2011, 7:16am Ken's absolutely right (unless node "2" has other connections ...). |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |