The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Command o create Netlist in Spectre https://designers-guide.org/forum/YaBB.pl?num=1304408728 Message started by analog_design on May 3rd, 2011, 12:45am |
Title: Command o create Netlist in Spectre Post by analog_design on May 3rd, 2011, 12:45am Hi, I want to run simulation through command prompt in spectre. Please, let me know what is command to create netlist from schematic circuit. I forgot it and try to look in to user manual but, I didnt find it. Please, explain me how i can run simulation without use of ADE ? You help would be appreciated. |
Title: Re: Command o create Netlist in Spectre Post by sheldon on May 3rd, 2011, 4:50am Analog_design, You will need to use ADE to create the netlist, or create it manually. To create a netlist in ADE, select Simulation --> Netlist --> Create or Recreate. Once you have the netlist you can simulate with Spectre from the command line so you can simulate without ADE. Best Regards, Sheldon |
Title: Re: Command o create Netlist in Spectre Post by boe on May 6th, 2011, 11:40am Analog_design, you can also use ADE to create OCEAN script for netlisting. B O E |
Title: Re: Command o create Netlist in Spectre Post by analog_design on May 8th, 2011, 9:54pm Thank you very much for your reply. I would like to simulate without use of ADE. i know the command to simulate i.e spectre xxx.scs but, I do not know the procedure to create netlist of circuit. Please, let me know the steps irrespective of use of ADE. your reply would be appreciated. Thank you. |
Title: Re: Command o create Netlist in Spectre Post by sheldon on May 9th, 2011, 3:59am Analog-design, You can simulate without the environment as described, using the spectre command. However, netlisting is not simulation, netlisting is part of the environment. Your options for netlisting are either interactive, ADE, batch mode, OCEAN, or manually creating the netlist. Best Regards, Sheldon |
Title: Re: Command o create Netlist in Spectre Post by boe on May 9th, 2011, 9:50am analog_design wrote on May 8th, 2011, 9:54pm:
As already stated, you could use an OCEAN script (assuming you have your design as a Cadence schematic). I am too busy to write code that I can have generated, so I always use ADE once to create an OCEAN script template for netlisting, which I modify as needed. B O E |
Title: Re: Command o create Netlist in Spectre Post by analog_design on May 12th, 2011, 11:35pm Hi All, Thank you very much to all for help and information |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |