The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> How to extract s-parameters from datapoints in Spectre ? https://designers-guide.org/forum/YaBB.pl?num=1305266644 Message started by Mayank on May 12th, 2011, 11:04pm |
Title: How to extract s-parameters from datapoints in Spectre ? Post by Mayank on May 12th, 2011, 11:04pm Hii, I gotta query. I have a table of Datapoints indicating Attenuation in dBs against corresponding frequencies, like FREQUENCY ---- ATTENUATION (MHz) (dB) 0.064 ----------------- 0.08 0.512 ----------------- 0.13 1.000 ----------------- 0.20 48.00 ----------------- 1.35 200.0 ----------------- 3.2 400.0 ----------------- 5.8 How do i model a TLINE in SPECTRE with these parameters so as to extract s-parameters out of it ?? -- Thanks, Mayank. |
Title: Re: How to extract s-parameters from datapoints in Spectre ? Post by weber8722 on Nov 17th, 2011, 8:41am Hi, I would create a little s2p file for my own with f s11 s21 s12 s22 in dB and with phase in degrees. You can directly use your values, but need to add the phase too - simple if you know the length. :) Spectre can include this s2p file using analogLib/nport. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |