The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> attach detection for USB OTG device https://designers-guide.org/forum/YaBB.pl?num=1307009768 Message started by sam.z on Jun 2nd, 2011, 3:16am |
Title: attach detection for USB OTG device Post by sam.z on Jun 2nd, 2011, 3:16am Hi, Is there any way to know whether the USB plug(OTG) was attached or not? (Only Vbus pin is avaliable) From the OTG USB2.0 spec, there is a 1~6.5uF cap at VBUS node. Any one knows the way to detect the Cap? Thanks a lot , Sam |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |