The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> phase of voltage /current of V source connected to resistor?
https://designers-guide.org/forum/YaBB.pl?num=1308470946

Message started by The Falcon on Jun 19^th, 2011, 1:09am

Title: phase of voltage /current of V source connected to resistor?
Post by The Falcon on Jun 19^th, 2011, 1:09am

Hi
in virtuoso
when i measure the phase of the voltage source it 's shown -90 ? why not zero. however, its connected to resistor?
when measure phase of the current you find it +90 , which i interpret as it measure current sinked to the element (which is the voltage source here), isn't it?

Thanks