The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> can cadence plot signals automatically after PSS like transient?
https://designers-guide.org/forum/YaBB.pl?num=1308471211

Message started by The Falcon on Jun 19^th, 2011, 1:13am

Title: can cadence plot signals automatically after PSS like transient?
Post by The Falcon on Jun 19^th, 2011, 1:13am

Hi
In Cadence IC 6
could cadence plot pre-selected signals ( waveforms ) automatically after running pss analysis without going to direct plot / mainform ?

ADE do this in transient could it do that for pss also?

Thanks

Title: Re: can cadence plot signals automatically after PSS like transient?
Post by ywguo on Jun 21^st, 2011, 5:55pm

Choose the signal you want to plot in Results Browser after first run. In pss-td.pss, choose the signal, RMB click and select Calculator. Then the signal is put in the Calculator, looks like v("signal_name" ?result "pss-fd.pss").

After that, choose Outputs --> Setup in ADE. Get the expression from the Calculator and name it. Click OK or Apply to add the expression.

Now the PSS result for that signal will be plotted after next run.

Best Regards,
Yawei

Title: Re: can cadence plot signals automatically after PSS like transient?
Post by The Falcon on Jun 28^th, 2011, 5:12am

Thank you ywguo