The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> VCO simulation question ?
https://designers-guide.org/forum/YaBB.pl?num=1310913833

Message started by The Falcon on Jul 17^th, 2011, 7:43am

Title: VCO simulation question ?
Post by The Falcon on Jul 17^th, 2011, 7:43am

Hi

in OOK VCO, it oscillates in first cycle only and OFF in OFF period and not re-oscillates again as there's no intial condition " that i think !"

how to set a dynamic Initial condition that let the vco oscillates at each cycle?

Thanks