The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> Standard cells unresolved in myDesign https://designers-guide.org/forum/YaBB.pl?num=1318061356 Message started by ywguo on Oct 8th, 2011, 1:09am |
Title: Standard cells unresolved in myDesign Post by ywguo on Oct 8th, 2011, 1:09am Hello Guys, I am doing post-PR simulation with AMS designer. Select Cellview-based netlister with ncvlog, ncelab, ncsim. It stops in elaberation phase with the following error. Code:
DL07D1 and NI01D5 are standard cells. I set the verilog file for standard file in ADE --> Simulation --> Options --> Compiler... --> Library Files/Directories. All the standard cells are compiled into myDesign_sim library. Then I fill myDesign_sim library name in Library list of Global Bindings. I have not figured out the cause. Any comments are appreciated. Best Regards Yawei |
Title: Re: Standard cells unresolved in myDesign Post by ywguo on Oct 9th, 2011, 5:34am I have figured out the issue. The standard cells are compiled in and default view name is module. The sub-blocks in myDesign is compiled in and default view name is module, too. So I need to put module in View list of Global Bindings. Now it is done. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |