The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> RF Measurements >> Balu-LNA design https://designers-guide.org/forum/YaBB.pl?num=1318928073 Message started by prakash@191 on Oct 18th, 2011, 1:54am |
Title: Balu-LNA design Post by prakash@191 on Oct 18th, 2011, 1:54am I have designed balun-LNA using parallel combination of CS and CG stage. My circuit has differential output and single ended input. I matched the input for 50ohms since it is single ended. But my doubt is how to match the differential output for 100ohms. For output impedance matching, i have separately matched the output for 50ohms assuming virtual ground.(for both outputs of CS and CG buffer stages). After matching i lifted the virtual ground and the output capacitors will come in series. I replaced them with single capacitor ( series combination). I haved used capacitors for matching purpose at the output of buffer stages. With this setup, i measured S22 by keeping port in between the terminals. I want to know whether my way of thinking is correct? Any help would be appreciated |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |