The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> about hspice output file https://designers-guide.org/forum/YaBB.pl?num=1319031562 Message started by lhlbluesky_lhl on Oct 19th, 2011, 6:39am |
Title: about hspice output file Post by lhlbluesky_lhl on Oct 19th, 2011, 6:39am when i do hspice simulation for tran analysis, the output files include only: *.ic0, *.st0, *.lis, and there is no *.tr0 file, why? is there anything wrong here? thanks. |
Title: Re: about hspice output file Post by Geoffrey_Coram on Oct 20th, 2011, 10:00am Any number of things could be wrong: 1) you didn't actually request a transient analysis 2) there was an error running the sim 3) your netlist didn't specify anything to go in the .tr0 file (perhaps you have a .measure?) Take a close look at the .options in the netlist and any errors/warnings in the .lis |
Title: Re: about hspice output file Post by raja.cedt on Oct 25th, 2011, 1:04am hello, apart from the above reasons if you forget to probe any node v or i then also it wont give any .tr0 file. Thanks, Raj. |
Title: Re: about hspice output file Post by spiceoracle on Nov 2nd, 2011, 9:02am Make sure that you have the statement: .option post in your netlist |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |