The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> circuit engineer vs system level engineer https://designers-guide.org/forum/YaBB.pl?num=1324300811 Message started by NTR on Dec 19th, 2011, 5:20am |
Title: circuit engineer vs system level engineer Post by NTR on Dec 19th, 2011, 5:20am Hi, can any one explain what to be extracted from system level simulations of RF front end(LNA,mixer) .what kind of parameters will be expected by circuit designer from guy doing system level simulation. Thank you for your time |
Title: Re: circuit engineer vs system level engineer Post by raja.cedt on Dec 19th, 2011, 6:10am hello, from the system level specification you will have derive what is total NF, linearity and etc requirements, then you have to decide how you have to budget among LNA, MIXER, another blocks. Please read some basic RF book, probably you get all system level specifications in the following book VLSI for Wireless Communication by Bosco Leung Thanks, Raj. |
Title: Re: circuit engineer vs system level engineer Post by loose-electron on Dec 19th, 2011, 12:06pm noise linearity spectral rejection of out of bad gain bandwidth min-max signal amplitudes min -max tolerances on all the above. Probably forgetting something, but thats the short list |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |