The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> simulate veriloga model using spectre only https://designers-guide.org/forum/YaBB.pl?num=1326384742 Message started by xuedashun on Jan 12th, 2012, 8:12am |
Title: simulate veriloga model using spectre only Post by xuedashun on Jan 12th, 2012, 8:12am I am using spectre to run a simulation. The testbench is very simiple and has a voltage source, a resistor and a diode. The diode has symbol view and veriloga view. But I have an error in the simulation log file: " ERROR: Netlister: unable to descend into any of the views defined in the view list "spectre cmos_sch cmos.sch schematic vedriloga ahds" for instance Idiode in cell....." I don't understand why it happens. It seems netlister can not find the veriloga view for the diode, but it's in my library. I remember specter supports veriloga model. (If I use config view for the testbench, it should be ok. I just want to use spectre only to simulate it) Could you give me some suggestion? Thank you!! |
Title: Re: simulate veriloga model using spectre only Post by rfidea on Jan 12th, 2012, 10:39am You have write "vedriloga " in your post. Was that the case in the simulator setup as well or did you to a typo in the post. |
Title: Re: simulate veriloga model using spectre only Post by Geoffrey_Coram on Jan 12th, 2012, 11:15am You should also search this forum for "veriloga view" -- there's some trick I remember reading about in another post, having to do with saving the view. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |