The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> PSRR simulation set-up of Bandgap Reference in Cadence
https://designers-guide.org/forum/YaBB.pl?num=1334060676

Message started by analog_design on Apr 10^th, 2012, 5:24am

Title: PSRR simulation set-up of Bandgap Reference in Cadence
Post by analog_design on Apr 10^th, 2012, 5:24am

Hi Folks,

I am trying to run PSRR simulation on Bandgap. I have design first order bandgap reference and I am facing difficulty while doing simulation of it.

Please, let me know How should I do set-up of PSRR Simulation in Cadence Spectre .

I would be thankful to you.

Thank you :)

Title: Re: PSRR simulation set-up of Bandgap Reference in Cadence
Post by tzg6sa on May 25^th, 2012, 6:50am

What is your exciting signal (input) in this case?
What is your output signal in this case?

If you know these than it is straightforward to simulate it.