The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> offset in Monte Carlo simulations
https://designers-guide.org/forum/YaBB.pl?num=1338104014

Message started by Ajay on May 27^th, 2012, 12:33am

Title: offset in Monte Carlo simulations
Post by Ajay on May 27^th, 2012, 12:33am

I had run a Monte Carlo simulation for determining the offset of an amplifier with 500 trials. At one of the trial, the offset was maximum.
* In CADENCE , how do I find the 'trial number' where the offset was maximum ?
* I would like to do a temperature sweep at the Monte Carlo trial where the offset is maximum.
Can someone give suggestions for doing the above in Cadence ?