The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Jitter Simulation of Frequency Divider https://designers-guide.org/forum/YaBB.pl?num=1341903588 Message started by Annie on Jul 9th, 2012, 11:59pm |
Title: Jitter Simulation of Frequency Divider Post by Annie on Jul 9th, 2012, 11:59pm Hi! Can anyone offer any help regarding PSS/Pnoise simulation of Frequency Divider in Spectre?I am interested in the Jitter Performance of the design. Thanks in anticipation. Regards, Annie |
Title: Re: Jitter Simulation of Frequency Divider Post by Frank Wiedmann on Jul 10th, 2012, 2:16am I suggest you start by reading the thread at http://www.designers-guide.org/Forum/YaBB.pl?num=1224609785 (all three pages), including the links given there. |
Title: Re: Jitter Simulation of Frequency Divider Post by Annie on Aug 15th, 2012, 4:40am Thanks a lot for the relevant help Frank. Just a little doubt regarding what are the sources considered in PNoise jitter analysis(only random or random+deterministic?).And how much accuracy can I expect if I calculate jitter using EyeDiagram function in Cadence Calculator? |
Title: Re: Jitter Simulation of Frequency Divider Post by Frank Wiedmann on Aug 16th, 2012, 1:31am PNoise jitter analysis is a type of noise analysis and so only considers random noise sources. I don't have experience with the EyeDiagram function but the accuracy of a jitter measurement in the eye diagram will proabably also depend on the accuracy settings (conservative/moderate/liberal) of the transient simulation. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |