The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> monte carlo trimmed simulation in adexl (cadence 6)
https://designers-guide.org/forum/YaBB.pl?num=1343830577

Message started by tempora123 on Aug 1^st, 2012, 7:16am

Title: monte carlo trimmed simulation in adexl (cadence 6)
Post by tempora123 on Aug 1^st, 2012, 7:16am

Hi,

Does anyone know how to setup monte carlo simulation under adexl in such way that:
- 1st test bench uses tran smulation to find a trimming code for a particular instance (DUT)
- 2nd test bench uses dc temp sweep to run a monte carlo trimmed simulation
In both test benches DUT should contain devices with the same mismatch spread on their model parameters.

Thanks for your help.