The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to get device width and length in a dc sweep simulation of spectre
https://designers-guide.org/forum/YaBB.pl?num=1345297341

Message started by avlsi on Aug 18^th, 2012, 6:42am

Title: how to get device width and length in a dc sweep simulation of spectre
Post by avlsi on Aug 18^th, 2012, 6:42am

Hi,
I am using spectre for the first time.
I am trying to generate gm/ID curves from a simulation.
Post processing is done in perl.
I could get device params like gm,ID,cgd etc using getData("NM0:gm") etc.
But what is the command to get the length and width of the device.

-- Avlsi