The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> Low power transceiver
https://designers-guide.org/forum/YaBB.pl?num=1348069215

Message started by mixed_signal on Sep 19^th, 2012, 8:40am

Title: Low power transceiver
Post by mixed_signal on Sep 19^th, 2012, 8:40am

Hi,
I am working on a low power transceiver for Wireless Body area network protocol. How do I get the phase noise specs of my PLL from the protocol specs. The protocol specifies the transmitter specs like EIRP, transmit mask etc. and receiver specs like sensitivity , ACPR etc.

Title: Re: Low power transceiver
Post by loose-electron on Sep 22^nd, 2012, 12:17pm

you are using this for up convert mixing correct?

Phase noise of the mix product converts to spectral spreading of the output.