The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Modeling >> Behavioral Models >> setting parameters in verilogams to vary with corners https://designers-guide.org/forum/YaBB.pl?num=1360172395 Message started by sammy_bee on Feb 6th, 2013, 9:39am |
Title: setting parameters in verilogams to vary with corners Post by sammy_bee on Feb 6th, 2013, 9:39am Hi All , I m new to verilogams. My verilogams module works fine with norminal model. Now i want to vary a parameter based on the digital corner being used my the simulator. For instance if the simulator is using strong models , I want to set parameter P = 1 and if it is using weak models , set P =2 .Can any of you provide me with help on how to do this? |
Title: Re: setting parameters in verilogams to vary with corners Post by spinfab on May 16th, 2013, 4:50am Hello, The best way to do so, is to use a model card approach, i.e writing spectre netlist with 'model' statment. fab |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |