The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> about stability (kf,b1f) simulation for mixer https://designers-guide.org/forum/YaBB.pl?num=1377479963 Message started by bbtuotuo on Aug 25th, 2013, 6:19pm |
Title: about stability (kf,b1f) simulation for mixer Post by bbtuotuo on Aug 25th, 2013, 6:19pm Dear All, I would like to know whether we can use the sp or (psp or hbsp) to simulate the stability (kf, b1f) performance for a circuit like mixer (or Tx or Rx). K factor (kf) and b1f are used to check the stability of a linear circuit, right? Does this mean that we can not use these parameters to check the stability of a mixer? If this is true, then how can we check the stability of the mixer or the whole Tx or Rx? Thanks in advance. tuotuo |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |