The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> PowerSupply desing for RF board https://designers-guide.org/forum/YaBB.pl?num=1380705279 Message started by phenning on Oct 2nd, 2013, 2:14am |
Title: PowerSupply desing for RF board Post by phenning on Oct 2nd, 2013, 2:14am I have a RF board 900 -2.5GHz with 4 channels that run through LNA, demuxer another amplifiers and then ADC. On the current board each of these devices has their own dedicated low noise LDO regulator. this set of regulators are reproduces 4 times. Is this the best practice in terms of noise separation or could you get by with sharing a LDO across the 4 channels? and between devices? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |