The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> ADS Antenna Simulation issue https://designers-guide.org/forum/YaBB.pl?num=1381412953 Message started by bradsdr on Oct 10th, 2013, 6:49am |
Title: ADS Antenna Simulation issue Post by bradsdr on Oct 10th, 2013, 6:49am Dear Members, I am new to this forum. I am trying to simulate a microstrip patch antenna in ADS momentum. The tutorial I am following is http://www.carlomozetic.net/userfiles/Tutorial_ADS_momentum.pdf But results of my simulations are not right I think. I have also attached my results ![]() Any pointers on what could be the issue ? Any tutorial on designing a microstrip patch antenna would be appreciated. -- |
Title: Re: ADS Antenna Simulation issue Post by harpoon on Oct 11th, 2013, 1:29am Looks like a Test bench or setup issue. Are you sure you have the right model files ? I have not used Momentum before, but I am guessing you need to setup the material properties and antenna X-Y-Z dimensions. I am guessing you'll need ports correctly inserted for it to work. If possible, look at tutorials from ADS first to get a hang of the tool. Good luck and don't forget to report back on where it went wrong and how you fixed it ... |
Title: Re: ADS Antenna Simulation issue Post by bradsdr on Oct 11th, 2013, 9:43am I went through the tutorial again and couldn't find any issue that could give false results. I set material properties and and antenna dimensions similar to what is given in the tutorial. My antenna layout looks like this ![]() I would definitely give feedback on the forum after resolving the issue. |
Title: Re: ADS Antenna Simulation issue Post by harpoon on Oct 11th, 2013, 11:42am One suggestion, can you add another port on your antenna and plot s21 ? Or better still ... Make a 50 ohm line, put 2 ports at 2 ends, and plot s21. Change to 75ohm and resimulate Just to confirm momentum is working ... |
Title: Re: ADS Antenna Simulation issue Post by bradsdr on Oct 13th, 2013, 12:26am Thanks for your suggestion. Momentum is working fine. I say this because example that come with momentum is working fine... I am lost here! |
Title: Re: ADS Antenna Simulation issue Post by bradsdr on Oct 13th, 2013, 12:32am Another question! How can I find the input impedance of schottky diode using ADS simulation? I want to find out impedance on 2.45 GHz ? |
Title: Re: ADS Antenna Simulation issue Post by harpoon on Oct 14th, 2013, 12:33am I do not have ADS ... but I imagine you can put a DC voltage port on the diode, vary the DC voltage and plot S11 ? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |