The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> Why the circuit is behaving so? https://designers-guide.org/forum/YaBB.pl?num=1385030549 Message started by shaikss_rf on Nov 21st, 2013, 2:42am |
Title: Why the circuit is behaving so? Post by shaikss_rf on Nov 21st, 2013, 2:42am Hi, I used SPDT switch to enable/disable one of the topologies. When I tried yesterday with single stage of rectifier topology, it was working fine. Today, I simulated the similar concept with multi-stage rectifier for both topologies. I see some strange results. Can you pls explain why there is change in behavior of signal? In this zip file, 1.png is the waveform which I observed for the SPDT switch with no load. multi_1.png is the plot when load (rectifiers) are present. multi_2.png is the circuit diagram of complete design and the last fig is the zoomed version of SPDT switch. Request you to pls help me. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |