The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to add customer model to a device in Cadence
https://designers-guide.org/forum/YaBB.pl?num=1400855638

Message started by rf_man on May 23^rd, 2014, 7:33am

Title: how to add customer model to a device in Cadence
Post by rf_man on May 23^rd, 2014, 7:33am

Hi,

I want to simulate a customer-made device. I've got the model file, but I don't know how to couple the model file to the device. Does anyone can help?

Kind regards,

Title: Re: how to add customer model to a device in Cadence
Post by sheldon on May 25^th, 2014, 5:16am

RF_Man,

If it is a standard model. Use a symbol from analogLib in the
schematic, for example, analogLib mos4. Enter your model name
as the model name. Then in the simulator options include the
your file.

Sheldon

Title: Re: how to add customer model to a device in Cadence
Post by rf_man on May 26^th, 2014, 12:24am

Sheldon,

It's not a standard model. How should it be done then?

Title: Re: how to add customer model to a device in Cadence
Post by sheldon on May 26^th, 2014, 3:33am

RF-man,

By a standard model, I meant a model supported by the simulator.
If the simulator supports the model, then you need to define the model
and the path to the model parameters. If the simulator does not
support the model, then you will need to create/define the model,
as well as, define the name and the path to the model parameters.

Sheldon