The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Where the "dc_pivot_check=yes" is?
https://designers-guide.org/forum/YaBB.pl?num=1401327114

Message started by Jacki on May 28^th, 2014, 6:31pm

Title: Where the "dc_pivot_check=yes" is?
Post by Jacki on May 28^th, 2014, 6:31pm

Hi,

I face the similar problem as explain in this link below (Cadence community)
http://www.cadence.com/Community/forums/p/24913/1319397.aspx

The explanation in this link is quite good, but I can only find the "pivotdc=yes", cannot find "dc_pivot_check=yes".

I am using mmsim 11, can anybody tell me where I can set up the "dc_pivot_check=yes"?

Thank you.
Jacki