The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> 2 tone design in ADS https://designers-guide.org/forum/YaBB.pl?num=1404966715 Message started by Anik on Jul 9th, 2014, 9:31pm |
Title: 2 tone design in ADS Post by Anik on Jul 9th, 2014, 9:31pm Hi, I'm new in this forum, and ADS software/RF design as well. I want to design 2 tone signal in ADS and look at the efficiency performance. I have take a look at the designguide in ADS software, under “amplifier” and “loadpull” 2 tone. My problem is, I do not know how to interpret the efficiency plot for Doherty PA, seems the plot are in time domain and frequency domain. Could you pls assist me in this matter. Many thanks! |
Title: Re: 2 tone design in ADS Post by cheap_salary on Jul 13th, 2014, 4:22am Two tones signal are equivalent to DSB AM(Amplitude Modulation) Signal without carrier. Consider efficiency as DSB AM generator. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |