The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to selectively run monte carlo on a subcircuit block in Hspice https://designers-guide.org/forum/YaBB.pl?num=1406859531 Message started by blam on Jul 31st, 2014, 7:18pm |
Title: how to selectively run monte carlo on a subcircuit block in Hspice Post by blam on Jul 31st, 2014, 7:18pm For a large circuit consisting of several subcircuits, if I want to see which subcircuit is most sensitive to process variation, which means variation of the subcircuit has the most contrition to the overall variation on top level, is there a way to run hspice on the top level and monte carlo for a single subcircuit at the same time? This way I think I can break down the contribution from each subcircuit. Thanks! |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |