The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Noise correlation simulation in pnoise https://designers-guide.org/forum/YaBB.pl?num=1412317581 Message started by mixed_signal on Oct 2nd, 2014, 11:26pm |
Title: Noise correlation simulation in pnoise Post by mixed_signal on Oct 2nd, 2014, 11:26pm Hi, 1. I am using IC6.1.6-64b.500.1 and my simulator version is 10.1.1.296.isr18 64 bit 2. I am simulating a basic downconversion mixer as shown in attached figure. I want to know the correlation between noise at RF (red) and noise at IF (blue). I tried to follow the following article: https://www.cadence.com/rl/Resources...rs/tdnoise.pdf In page 7, it uses noisetype=correlations. But this option is not available in this version. How shall I find my required correlation. I shall highly appreciate if some provides me an appnote or the steps. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |