The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to print all mos opertion point to a file with ocean
https://designers-guide.org/forum/YaBB.pl?num=1418913288

Message started by xianweng on Dec 18^th, 2014, 6:34am

Title: how to print all mos opertion point to a file with ocean
Post by xianweng on Dec 18^th, 2014, 6:34am

hi eyeryone,

i am using IC 615 and MMSIM13.1. i am going to save all mos opertion point to a file with ocean.I know that i could save single mos op with a expression like op("/M0" "vds"),but there are a lot of mos in my schematic.So which expression i should use? i have tried op("/*" "vds"),but it is does not work .could you help me figure this out?

thanks you