The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> User defined resistor model in Cadence Spectre https://designers-guide.org/forum/YaBB.pl?num=1423588857 Message started by jdp on Feb 10th, 2015, 9:20am |
Title: User defined resistor model in Cadence Spectre Post by jdp on Feb 10th, 2015, 9:20am Hello, I am trying to run the simple example as depicted in the image below. But, I am not able to implement the resistor (with some user defined parameters rsh and kf) as required here! :( For that, I tried to take a "res" from analogLib, and then change its "model name" to say "flickres_jdp" and also made a model file (say flickres_jdp.scs) - then added this model file from ADE->Setup->Model Path The text put in this model file is: Quote:
Getting following error: Quote:
My questions: 1. Is the above method okay, and is the format of the model file right? 2. Is there any option to include a ".model" statement in the schematic editor in cadence? 3. Is there any way to edit the netlist and then run the simulation? These might be very trivial..but please help... :-/ |
Title: Re: User defined resistor model in Cadence Spectre Post by Geoffrey_Coram on Mar 13th, 2015, 11:03am .model is not Spectre format. Did you get any warnings at the start of the simulation? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |