|
The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> ESD protection for multi-supply https://designers-guide.org/forum/YaBB.pl?num=1426747114 Message started by newic on Mar 18th, 2015, 11:38pm |
|
Title: ESD protection for multi-supply Post by newic on Mar 18th, 2015, 11:38pm Hi How is the ESD protection scheme for multi-supply system? I am more concerns on ESD event from VDD1 to VDD2, assume VDD2 is a reference during ESD event. I read some books that recommends to add bidirectional diode between 2 supplies. But it will cause leakage during power up event. is it a practical solution? Is there any good solution? |
|
Title: Re: ESD protection for multi-supply Post by newic on Apr 14th, 2015, 7:41pm any expert can comment?? |
|
Title: Re: ESD protection for multi-supply Post by RobG on Apr 15th, 2015, 2:49am I'm not even close to an expert, but the Vdd pads I see these days have a snapback device between the pad and ground. This protects each Vdd pad relative to ground so there is no need to put diodes between the separate Vdds. |
|
Title: Re: ESD protection for multi-supply Post by newic on Apr 16th, 2015, 12:54am hi It is true that each supplies has a clamp between vdd1/2 to vss. But the clamp will not turn on if Vdd1 & Vdd2 did not have a common ground. The charge can go from vdd1 to vdd2 through the level shifter circuit instead of going through vss. assume Vdd1 pairs with vss1 while vdd2 pairs with vss2. |
|
Title: Re: ESD protection for multi-supply Post by RobG on Apr 16th, 2015, 1:53am I guess you would have your snapbacks between the vdd pads and a common line, such as substrate or one of the vss lines. Then put back-to-back diodes between the vss pads. |
|
Title: Re: ESD protection for multi-supply Post by newic on Apr 16th, 2015, 10:13pm Hi RobG, it is not a snapback ESD device at the power supplies. CMOS RC-Triggered MOSFET ESD Power Clamp is used instead. Is there a problem? |
|
Title: Re: ESD protection for multi-supply Post by RobG on Apr 17th, 2015, 7:08am Yes, same idea. I see my Vdd pads use the RC clamps. |
|
Title: Re: ESD protection for multi-supply Post by newic on Apr 22nd, 2015, 1:13am thx!! |
|
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |