The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design Languages >> Verilog-AMS >> Why there is no sine wave after adding a digital module? https://designers-guide.org/forum/YaBB.pl?num=1427814612 Message started by ruwan2 on Mar 31st, 2015, 8:10am |
Title: Why there is no sine wave after adding a digital module? Post by ruwan2 on Mar 31st, 2015, 8:10am Hi, I am learning verilog-AMS. When I only use sine wave module sinVarFreq, there is a sine wave in the transient analysis. If I add a digital module, please see the full code in the following snippnet, there is no sine wave in transient window. What is missing if there are both digital and analog in a project? Thanks, Code:
|
Title: Re: Why there is no sine wave after adding a digital module? Post by boulate on Apr 1st, 2015, 9:14pm Hi, Your verilog-a source is floating, try to replace xsine src src_n sinVarFreq by xsine src 0 sinVarFreq |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |