The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design Languages >> VHDL-AMS >> Modelling of Vibratory Gyroscope using VHDL-AMS https://designers-guide.org/forum/YaBB.pl?num=1435138061 Message started by Harry_108 on Jun 24th, 2015, 2:27am |
Title: Modelling of Vibratory Gyroscope using VHDL-AMS Post by Harry_108 on Jun 24th, 2015, 2:27am Hi, I need little conceptual help on 2DOF vibratory gyroscope (please check the attached file). I am modelling Mass spring damper system using VHDL-AMS. in the design I have two mechanical resonator I have done following connections. terminal t1: translational; there are 2 springs, 2 dampers and 2 masses in the system suffix 1 is used for drive and 2 is used for sense resonator spring_1: P end is connected to traslational_ref; n end is connected to t1; Damper_1: P end is connected to traslational_ref; n end is connected to t1; Mass_1: (has only one end) p end is connected to t1; now my question is how to connect spring_2, Damper_2 and Mass_2 ??? appreciate your earlier replies. thanks, Harry_108 |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |